MSD Distributor Hold-Down Clamp Billet Steel Chev 350 454 # MSD8110

Valve Spring Set for 1989-2002 Nissan Silvia & 180SX by Tomei

When installing aftermarket valve springs in a head assembly, the amount of load applied to each spring need to be adjusted until everything is in uniform specification. This is a standard procedure which all race engines go through in order to be able to raise the engine RPM without any glitches or hesitation. The standard method involved when putting together the valve assembly is to fully balance all the added components to tighter clearances than the manufacturer specifications. This method called blueprinting can be time consuming and a very costly service performed by an experienced engine builder. By utilizing the various thickness of the spring seats to adjust to each and different spring rate load, the same objective can be satisfied with fraction of the cost.

When installing Tomei Type A valve springs in an RB26 and performing a three angle valve job, the stock spring load spec of 24kg is decreased to less than 20kg. By installing the Tomei Valve Spring Seats, the spring load can be brought back to tolerance to the 24kg range, enabling the engine to rev freely once again.

Applications

• 1989-2002 Nissan Silvia & 180SX
• Engines Covered: SR20DET & SR20DE

What’s In The Box?

• 1 – Set of Valve Seats

References

• Tomei’s Valve Seat Guide